Mitigation of interfacial dielectric loss in aluminum-on-silicon superconducting qubits

• URL: http://arxiv.org/abs/2310.06797v1
• Date: Tue, 10 Oct 2023 17:08:59 GMT
• Title: Mitigation of interfacial dielectric loss in aluminum-on-silicon superconducting qubits
• Authors: Janka Bizn\'arov\'a, Amr Osman, Emil Rehnman, Lert Chayanun, Christian Kri\v{z}an, Per Malmberg, Marcus Rommel, Christopher Warren, Per Delsing, August Yurgens, Jonas Bylander and Anita Fadavi Roudsari
• Abstract summary: We demonstrate aluminum-on-Silicon planar transmon qubits with time-averaged energy relaxation times of up to $270,mu s$, corresponding to Q = 5 million, and a highest observed value of $501,mu s$. The mitigation of loss is achieved by reducing the presence of oxide, a known host of defects, near the substrate-metal interface.
• Score: 0.0
• License: http://arxiv.org/licenses/nonexclusive-distrib/1.0/
• Abstract: We demonstrate aluminum-on-silicon planar transmon qubits with time-averaged ${T_1}$ energy relaxation times of up to ${270\,\mu s}$, corresponding to Q = 5 million, and a highest observed value of ${501\,\mu s}$. We use materials analysis techniques and numerical simulations to investigate the dominant sources of energy loss, and devise and demonstrate a strategy towards mitigating them. The mitigation of loss is achieved by reducing the presence of oxide, a known host of defects, near the substrate-metal interface, by growing aluminum films thicker than 300 nm. A loss analysis of coplanar-waveguide resonators shows that the improvement is owing to a reduction of dielectric loss due to two-level system defects. We perform time-of-flight secondary ion mass spectrometry and observe a reduced presence of oxygen at the substrate-metal interface for the thicker films. The correlation between the enhanced performance and the film thickness is due to the tendency of aluminum to grow in columnar structures of parallel grain boundaries, where the size of the grain depends on the film thickness: transmission electron microscopy imaging shows that the thicker film has larger grains and consequently fewer grain boundaries containing oxide near this interface. These conclusions are supported by numerical simulations of the different loss contributions in the device.

Related papers

• Site-Controlled Purcell-Induced Bright Single Photon Emitters in Hexagonal Boron Nitride [62.170141783047974]
  Single photon emitters hosted in hexagonal boron nitride (hBN) are essential building blocks for quantum photonic technologies that operate at room temperature. We experimentally demonstrate large-area arrays of plasmonic nanoresonators for Purcell-induced site-controlled SPEs. Our results offer arrays of bright, heterogeneously integrated quantum light sources, paving the way for robust and scalable quantum information systems.
  arXiv  Detail & Related papers  (2024-05-03T23:02:30Z)
• Characterization of process-related interfacial dielectric loss in aluminum-on-silicon by resonator microwave measurements, materials analysis, and imaging [0.0]
  We investigate the influence of the fabrication process on dielectric loss in aluminum-on-silicon superconducting coplanar waveguide resonators. These devices are essential components in superconducting quantum processors. We identify the relative importance of reducing loss at the substrate-metal and the substrate-air interfaces.
  arXiv  Detail & Related papers  (2024-03-01T18:16:28Z)
• Reducing two-level system dissipations in 3D superconducting Niobium resonators by atomic layer deposition and high temperature heat treatment [4.520721347047517]
  We demonstrate the reduction of two-level system losses in three-dimensional superconducting radio frequency (SRF) niobium resonators by atomic layer deposition (ALD) of a 10 nm aluminum oxide Al2O3 thin films. We witness a dissolution of niobium native oxides and the modification of the Al2O3-Nb interface.
  arXiv  Detail & Related papers  (2024-02-06T16:40:52Z)
• Microwave loss characterization using multi-mode superconducting resonators [0.0]
  We introduce a method to measure the microwave losses of materials and interfaces with a single multi-mode superconducting resonator. We present two types of multi-mode superconducting resonators for the study of bulk superconductors.
  arXiv  Detail & Related papers  (2023-05-03T03:10:41Z)
• Disentangling Losses in Tantalum Superconducting Circuits [40.00209231119813]
  Recently discovered tantalum-based qubits exhibit record lifetimes exceeding 0.3 ms. By studying the dependence of loss on temperature, microwave photon number, and device geometry, we quantify materials-related losses. With four different surface conditions, we quantitatively extract the linear absorption associated with different surface TLS sources. Finally, we quantify the impact of the chemical processing at single photon powers, the relevant conditions for qubit device performance.
  arXiv  Detail & Related papers  (2023-01-19T02:02:37Z)
• Precision measurement of the microwave dielectric loss of sapphire in the quantum regime with parts-per-billion sensitivity [50.591267188664666]
  Dielectric loss is known to limit state-of-the-art superconducting qubit lifetimes. Recent experiments imply upper bounds on bulk dielectric loss tangents on the order of $100$ parts-per-billion. We have devised a measurement method capable of separating and resolving bulk dielectric loss with a sensitivity at the level of $5$ parts per billion.
  arXiv  Detail & Related papers  (2022-06-29T00:14:11Z)
• Ternary Metal Oxide Substrates for Superconducting Circuits [65.60958948226929]
  Substrate material imperfections and surface losses are one of the major factors limiting superconducting quantum circuitry from reaching the scale and complexity required to build a practicable quantum computer. Here, we examine two ternary metal oxide materials, spinel (MgAl2O4) and lanthanum aluminate (LaAlO3), with a focus on surface and interface characterization and preparation.
  arXiv  Detail & Related papers  (2022-01-17T06:10:15Z)
• TOF-SIMS Analysis of Decoherence Sources in Nb Superconducting Resonators [48.7576911714538]
  Superconducting qubits have emerged as a potentially foundational platform technology. Material quality and interfacial structures continue to curb device performance. Two-level system defects in the thin film and adjacent regions introduce noise and dissipate electromagnetic energy.
  arXiv  Detail & Related papers  (2021-08-30T22:22:47Z)
• Measurement of the Low-temperature Loss Tangent of High-resistivity Silicon with a High Q-factor Superconducting Resonator [58.720142291102135]
  We present the direct loss tangent measurement of a high-resist intrinsicivity (100) silicon wafer in the temperature range from 70 mK to 1 K. The measurement was performed using a technique that takes advantage of a high quality factor superconducting niobium resonator.
  arXiv  Detail & Related papers  (2021-08-19T20:13:07Z)
• Microscopic Relaxation Channels in Materials for Superconducting Qubits [76.84500123816078]
  We show correlations between $T_$ and grain size, enhanced oxygen diffusion along grain boundaries, and concentration of suboxides near the surface. Physical mechanisms connect these microscopic properties to residual surface resistance and $T_$ through losses arising from the grain boundaries and from defects in the suboxides. This comprehensive approach to understanding qubit decoherence charts a pathway for materials-driven improvements of superconducting qubit performance.
  arXiv  Detail & Related papers  (2020-04-06T18:01:15Z)

This list is automatically generated from the titles and abstracts of the papers in this site.

This site does not guarantee the quality of this site (including all information) and is not responsible for any consequences.